LCD Panel Walk Through Metal Detector -CE FCC Approved

LCD Panel Walk Through Metal Detector -CE FCC Approved

Inquire Now

Description:

Reasons to choose CheckPoint walk-through metal detector:
1) Deters crime
2) Improves traffic flow
3) Reduces the number of required searches
4) Reduces workload of security personnel
5) Reduces false alarms
6) Increases building safety with minimal cost
7) Durable material adoption

This walk-through metal detector can be used in the factory, prison, court, exhibition hall, stadium and entertainment lieu, where the prohibited articles need to be checked for safety.

Uniform detection:
The field of detection is uniform from top-to-bottom with no hot spots or dead spots.  In situations where large amounts of steel re-bar exist in a support floor and cause a drop in detection at ankle height; the loss can be compensated by adjusting the sensitivity of the floor level zone. The sensitivity of all six zones can be adjusted independently. They allow uniform detection to be maintained in all regions of the detector. Horizontal Axis Gain Control compensates for detection losses caused by external metal in walls or furniture. It adjusts the sensitivity horizontally across each zone.

Multiple operating frequencies:
The CheckPoint CS-DP provides eight user selectable operating frequencies.  They allow simultaneous operation of multiple units without interconnecting slaving cables.

Memory:
The CheckPoint CS-D utilizes an embedded microprocessor that analyzes data generated by 12 detection sensors. Whenever adjustments are made to any operating parameter, they are automatically retained in memory. When detector is powered down the previously entered perating parameters are retained in memory.

System security:
CheckPoint CS-DP is pass-code protected and has a locking key switch that connects the AC power. A four digit pass code must be entered before operating parameters can be accessed and changed.

Construction:
The CheckPoint CS-DP is coated in a durable scratch resistant two part epoxy finish. The side panels and header assembly are sturdily constructed for stability and durability.

System diagnostics:
The CheckPoint CS-DA/DII has self-diagnostic test routines. When the unit is powered on, it automatically self-tests and calibrates itself to the surrounding environment. Periodic calibration is not needed.

We provide professional manual, including following information:
1) Adjusting security level    
2) security level  
3) Suggested security level for O.T.P.  
4) F.A.A. three gun test  
5) Suggested parameters for three-gun test  
6) Industrial applications  
7) Loss prevention application  
8) Eliminating false alarms
9) Operating multiple detectors in parallel  
10) Achieving uniform detection    
11) Supports floors with excessive structural metal
12) Need for detection enhancement  
13) Maintenance and repair
14) Warranty